|Burr processing machine|
|Sandblasting machine accessories|
|Shot blasting machine|
自动喷砂机 ，此机工作流程为上件、喷砂、一次清洗、二次清洗、三次清洗风干、热风干和下件等。 Wheel-type pass-through automatic wet-type automatic sand blasting machine . The working process of this machine is loading, sand blasting, primary cleaning, secondary cleaning, tertiary cleaning, air-drying, hot-air-drying, and lower-parts. Equipped with automatic separation of water and sand (automatically separate the broken sand material during blasting, using the principle of elutriation), automatic sand addition (automatically add sand material after detecting the concentration of sand and water to maintain the concentration of working sand and water), and automatic cleaning. Wash all the sand on the workpiece without leaving water drops on the workpiece.
喷砂加工 位，喷枪往复摆动对工件上表面进行 喷砂 清理加工，喷砂加工后工件继续运行到冲洗舱，冲洗水自动洒水冲洗对工件外表面清洗，清洗完成的工件进入下道吹净室，风刀对工件外表面清洗请理，最后工件进入到下道工序。 The working mode of the machine: After the workpiece enters the conveying line body, the conveying line brings the workpiece to the sand blasting processing position. The spray gun swings back and forth to perform sand blasting and cleaning on the upper surface of the workpiece. After the sand blasting, the workpiece continues to run to the flushing compartment, and the flushing water automatically Sprinkle water to clean the outer surface of the workpiece. The cleaned workpiece enters the next blowing room. The air knife cleans the outer surface of the workpiece. Finally, the workpiece enters the next process.
： Work flow :
Sand blasting process
1. Turn on the power and turn on the compressed air source;
2. Adjust various parameters;
3. Add an appropriate amount of sand to the sand hopper and close the doors of each equipment;
4. Start the pumping fan motor;
7. The workpiece automatically enters the blasting area;
9, automatic flushing spray;
10. The air knife blows clean;
11. The processing cycle is performed. (Speed can be adjusted according to the actual situation)